If you didn't find what you were looking for, try a new search!
I tend to use the DMT stones – 1200 (very fine) and 8000 (very very fine). Arkansas stones are good. I have had the opportunity to use a Shapton stone too and was very impressed with them (on my Christmas list).
I do have the DMT Wave. I believe that is 1200 mesh (or grit). It works OK, as long as you are very careful not to overdo it. With it being such an aggressive grit, it can easily re-shape the inside of the gouge. I have contacted them and asked if they can make it [...]
If I am understanding your question correctly, the angle of the chisel to the stone is 90 degrees. Watch the video again and notice my entire body moves along the edge of the stone which keeps the tool positioned at a 90 degree angle to the stone (not twisting or turning that angle). Be sure [...]
You should just be able to clean the stones with soap and water – maybe use a scrub brush? I have never had any problems so far with mine doing this. Make sure you use only water or water and a little “green” dish soap.
A good place to start is with my video about "Sharpening a Curved Gouge." If you take your time, and don’t try to rush it, you should be fine. The difficulties usually come when the process is rushed (tipping the tool up too much and only the edge is sharpened, for example). It’s a [...]
This Deluxe Carving Kit can be used to complete the FREE Beginner Lessons and will get you started on your woodcarving journey. The difference between this kit and the Basic Carving Kit is this includes DMT diamond stones instead of Arkansas Stones. The Getting Started page will help you begin. NOTE: This set does not [...]