Hi Mary,
I am preparing to try the fan carving and have printed out the template which indicates the dimensions as 4-11/16" x 9-3/4". When I checked the printout with a ruler the 4-11/16" dimension was correct but the 9-3/4" was actually 9-1/2". I'm guessing that it really doesn't matter very much, probably won't throw off the proportions significantly and the gouges/chisels recommended will still work. But, since I am new to this, I wanted to check before investing too much time and/or buying a new tool or two. Thanks.
Chris
Hi Chris,
I will need to double check this measurement on the template. But it is basically a perfect half-round. I am wondering whether it was printed out sightly distorted? Either way, in the whole scheme of things 1/4 inch will never be noticed with all that is happening in that design. Make it your own design by increasing or decreacing the number of rays, or making it oval rather than half-round, etc.
I find this video and all the rest in the beginners section to b e most impressive. I am not ready to enroll but will shortly as soon as I can acquire some tools of the trade. Presently I am a song bird carver of 11 years and a chip carver of this year. I have accumulated all the DVD's available in both of these specialties but I find your series far superior to any I have purchased. Being a lecturer of over 20 years I must comment that your mode of presentation far exceeds many of my colleagues in delivery, content, organization and demonstration. Thanking you in advance I hope to enroll soon.
Hello Cesar,
It is probably one of the biggest challenges with woodcarving. The more to work with wood, the easier it is to recognize grain direction. Often, the cuts you make will "speak" to you. If one direction snags or causes difficulty, turn around and go in the other direction. Practice, practice, practice! And don't forget to have fun while you discover!
Hello Cesar,
It is probably one of the biggest challenges with woodcarving. The more to work with wood, the easier it is to recognize grain direction. Often, the cuts you make will "speak" to you. If one direction snags or causes difficulty, turn around and go in the other direction. Practice, practice, practice! And don't forget to have fun while you discover!
From Chris Eurich on Carving a Traditional Fan - Episode 2
Go to comment2016/07/16 at 12:22 pm
From Mary May on Carving a Traditional Fan - Episode 2
Go to comment2016/07/16 at 2:07 pm
From Robert Perley on Workshop Tour - Beginner Lesson #16 - Introduction
Go to comment2016/07/15 at 12:51 pm
From Mary May on Workshop Tour - Beginner Lesson #16 - Introduction
Go to comment2016/07/16 at 1:59 pm
From Cesar ROCHA on Starting to Carve
Go to comment2016/07/14 at 2:49 am
From Mary May on Starting to Carve
Go to comment2016/07/16 at 1:59 pm
From Cesar ROCHA on Starting to Carve - Beginner Lesson #2
Go to comment2016/07/14 at 2:49 am
From Mary May on Starting to Carve - Beginner Lesson #2
Go to comment2016/07/16 at 1:59 pm
From nicholas yearwood on Carving a Celtic Cross
Go to comment2016/07/12 at 9:37 pm