Here are part numbers for my preferred tools. They are for your ordering convenience and are accurate at the time the information was last updated. It is your responsibility to double check them when making an order. I have no financial interest with this seller.
Part numbers on this page are from the catalog page at Tools for Working Wood. (opens new tab or window)
Note well: Some of my preferred sizes are not available in this brand. Where possible, a substitute within 2mm in width, or within 1 number of sweep is shown. The size in parenthesis shows the substitute size, usually the next smaller width, or the next best fitting sweep.
Last updated: May 1, 2015 9:15 am by Bob Easton
| Basic Set | STRAIGHT | FISHTAIL |
|---|---|---|
| 5 or 6mm v-chisel 60° | IL-39.1/4 | not applicable |
| #3, 6mm | IL-3.1/4 | IL-54x3.1/4 |
| #3, 14mm | IL-3.1/2 | IL-54x3.1/2 |
| #5, 14mm | IL-5.1/2 | IL-54x5.1/2 |
| #7, 6mm | IL-7.1/4 | not listed |
| #7, 14mm | IL-7.1/2 | IL-54x7.1/2 |
| Additional #1 | ||
| #1, 14mm flat chisel | IL-1.1/2 | IL-54x1.1/2 |
| #3, 3mm | IL-3.1/8 | IL-47.1/8 |
| #3, 18mm | IL-3.3/4 | IL-54x3.3/4 |
| #5, 6mm | IL-5.1/4 | IL-54x5.1/4 |
| #7, 10mm | IL-7.3/8 | IL-54x7.3/8 |
| #8, 10mm | L-8.3/8 | IL-54x8.3/8 |
| #11, 3mm | IL-11.1/8 | not applicable |
| Additional #2 | ||
| #1, 20mm flat chisel | IL-1.7/8 | IL-54x1.7/8 |
| #4, 14mm | IL-4.1/2 | IL-54x4.1/2 |
| #6, 8mm | IL-6.5/16 | IL-54x6.1/4 (6mm) |
| #7, 8mm | IL-7.5/16 | IL-54x7.1/4 (6mm) |
| #7, 12mm | IL-7.7/16 | IL-54x7.7/16 |
| #8, 6mm | IL-8.1/4 | IL-54x8.1/4 |
| #10, 5mm | IL-10.3/16 | Il-54x10.1/4 (6mm) |
| #11, 5mm | IL-11.3/16 | not applicable |
| 3 or 4mm v-chisel 60° | IL-39.1/8 | not applicable |
| Specialty | ||
| 6mm skew chisel | IL-2.1/4 | not applicable |
| #4, 6mm spoon bent (for lowering the background in very low, awkward areas) | IL-25.1/4 | not applicable |
| #8, 10mm spoon bent (ball and claw foot lesson) | not listed | not applicable |
| #5, 12mm back bent (for shell carving) | IL-35.3/8 (10mm | not applicable |