Making a Rubber Mold of a Carving

2017-04-09T00:47:12+00:00 January 1st, 2014|

mold-500

This lesson shows the process of making a silicone rubber mold of a finished carving. You can use this process if you want to duplicate any of your carvings.

= More Lessons at the Basic Skill Level =

4 Comments

  1. Owen Burt December 7, 2014 at 1:55 pm - Reply

    How much is this lesson, “Making a Rubber Mold of a Carving” and how do I purchase it?

    How much is your starter carving tool kit?

    • Bob Easton December 7, 2014 at 2:52 pm - Reply

      Hi Owen,
      “Making a Rubber Mold” is one of the lessons that we didn’t package up for individual sale, because it is shorter than most. It is just a little over 10 minutes long, a bit shorter than anything else we made available for individual sale.

      I just made it available as an individual lesson for $2.99. See the “Buy this lesson” button below the introduction or use this link:
      https://gumroad.com/l/eHAp

      • Salko Safic January 13, 2015 at 1:32 am - Reply

        It amazes me how honest you guys are may God give you more and bless you both through out your lives.

        • Mary May January 13, 2015 at 8:51 pm - Reply

          Thank you! May God bless you also!

Leave A Comment